The separate effects can be secured in the same way, by feeding the safety cable through the bracket of the
device.
Ensure that the safety cable has a load capacity of 10x the weight of the fixture and that the device can not
fall further than 30 cm. You can wrap the safety cable around the truss or light stand several times to ensure
the fall is as short as possible. The shorter the fall, the less chance of damage or injury.
Light source
The Compar Kit FX1 contains powerful LED modules that create an even more powerful effect thanks to a
special lens that bundles the beams together. Never look directly into the lens from close range, as the
human eye can't adjust to the sudden intensity of the beam of light this device produces. It won't result in
permanent damage, but it can cause temporary blind spots which may cause disorientation and discomfort.
Spotlights
The spotlights on the Compar Kit FX1 each have a flexible gooseneck that allows their position to be easily
adjusted by hand. Simply move them until they give off light in the direction and at the angle required.
Don't rotate the spotlights by more than 180 degrees horizontally around their axis in order to prevent
damage to the gooseneck and the cabling that runs through them. Adjust the gooseneck with care and don't
force it into certain positions.
Laser
This device is equipped with a laser light effect. The use of lasers is not without danger and, depending on
where you use the laser, may be subject to legal requirements. Before you use the laser, please check any
legal requirements with your local authority. It's important to know what class the laser is in. This product has
a laser with a 3R class rating.
The laser sources inside the product have a 3B class rating. Do not open the housing or remove any screws,
panels or any other part of the housing. Before using the product, check that the housing of the laser is not
damaged. If the housing is damaged, the product should not be used. Contact your supplier to check if it can
be used safely.
The Compar Kit FX's laser has grating lens system. A laser can be a very dangerous light source because it
emits an extremely intense beam with a very narrow dispersion range which can cause damage to the
human eye when used incorrectly.
The Compar Kit FX1's lasers shine onto an optical disc that breaks the beam up into hundreds of separate
light beams which means the power of an individually projected laser light beam is not dangerous. However,
it's still recommended to ensure a minimum distance of 30 cm is kept between a person and the laser
because the light rays still converge in the source of the device. Thanks to the construction of the laser
effect, this device has a 3R class rating and meets the relevant requirements in standard IEC-60825 : 1-
2014 .
This device's laser is locked with a key and 2 keys are provided to lock and unlock it. This prevents it from
being used unintentionally. Always make sure that a minimum distance of at least 30 cm is maintained
between the laser light effect and the human eye.
Before use, always check whether the optical component of the laser is still present. If not, a dangerous
static laser beam can be produced when the laser is switched on!
The laser sources in the device have the following properties:
Green:
wavelength: 532 nm
CW/Pulsed: pulsed
max. peak power output (after optics): 3.80 mW
nominal max. output laser diode in device: 50 mW
Red:
wavelength: 659 nm
CW/Pulsed: pulsed
max. peak power output (after optics): 1.50 mW
The information in this user manual is subject to change at any time without notice.
Version:
1.0
Date of creation and author's initials:30-04-2018 RV Revision date and author's initials: -
To Next Page
Loading...
