Operation and mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During startup, ‘ES 4’ will be shown on the display and the device cannot be used. As soon as the device is
ready to use, it will enter the mode last used. Operation modes and other settings shown on the display can
now be adjusted or changed by using the menu buttons.
Should the device detect a DMX signal, it will automatically switch to DMX mode and will display the address
last used. For new devices, this will normally be DMX address 001. Of course, you can change the DMX
address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press 'enter'
to select a function or confirm an adjustment, use ‘up’ and ‘down’ to change values and ‘menu’ to go back to
the menu. By holding the ‘menu’ button down for 2 seconds after saving a specific setting, the device will
return to operation mode and the setting will be adopted. This will also be done after any change are made to
the operation mode or DMX address. Note that holding the menu button down is not necessary for settings to
be adopted as this is done automatically by the device a few seconds after new settings have been
confirmed.
The menu contains the following options and functions.
display Mode Function
ADDR / A001 DMX address configuration Address A001 … A512
CHND Channel mode selection 3CH/21CH/51CH channel modes
NASL Slave mode Master - (NAST)
Slave (SL 1)
SH L Show laser EL R = Laser random show
SH 1-5 = Laser show 1 - 5
OFF = Laser off
SPED = Laser speed 1 - 8
SH D Show laser + Derby ED R = Laser + derby random show
SH 1-6 = Laser + derby show 1-6
OFF = Laser + derby off
SPED = Laser derby speed 1 - 8
SH P Show 4 spotlights + strobe EP R= Par + strobe random show
SH 1-10 = Par + strobe show 1-10
OFF = Strobe off
SPED = Par + strobe speed 1 - 8
SH A Show all effects EA R = All random show
SH 1-5 = All show 1-5
OFF = All off
SPED = speed 1 - 8
SOUND Sound-controlled mode Mode: ON / OFF
SENS Sound sensitivity 0 - 100: sensitivity in %
DISP Display inversion LCD = ON/OFF
INVT = YES/NO
TEST Test mode The test program runs through each LED colour
one by one to check they are all functioning
correctly
TEMP Temperature in degrees Celsius 0 ~ 9999 temperature indicator
RST Reset Reset function (for restarting the device)
The information in this user manual is subject to change at any time without notice.
Version:
1.0
Date of creation and author's initials:30-04-2018 RV Revision date and author's initials: -
To Next Page
Loading...
