terminator
Signal loss or interference in the
DMX circuit
Close the DMX circuit with a
terminator or connect a booster
after a maximum of every 32
fixtures
The device is not reacting to DMX
commands
Incorrect DMX channel mode Check if the device is set to the
correct DMX channel mode
The operation mode can not be
changed
The device is in Slave mode If the device is in Slave mode, it
will wait for a master signal unless
there is a DMX signal present. Set
the device to Master to activate the
sound-controlled or automated
operation modes
The device is not responding to
the remote control
Battery empty If the battery in the remote control
is empty, replace it with an
equivalent CR2025 battery
Remote control not aimed properly Ensure that the remote control is
pointed towards the front panel of
the Compar Kit FX1 with a direct
'line of sight' between the remote
control and the device at a
distance of no more than 10
metres away. This gives the most
reliable result.
The information in this user manual is subject to change at any time without notice.
Version:
1.0
Date of creation and author's initials:30-04-2018 RV Revision date and author's initials: -
To Next Page
Loading...
