User Manual
Page 22 of 52
5. It is highly recommended to select the “Auto” mode for Channel
setting, this will allow your router to connect to the least congested Wi-
Fi channel at all times.
6. Select a Network Authentication method on the drop down list. By
default this is selected as Mixed WPA2/WPA-PSK.
7. Enter your preferred Network Key (Password).
8. Click the Save/Apply button to save and apply wireless settings.
Wi-Fi Protected Setup. Your router’s WPS button allows you to activate WiFi
Protected Setup (WPS). When you press the WPS button, it automatically
detects and connects wireless clients into the wireless network by
broadcasting the wireless network settings from your Access Point to you
wireless device/s.
It is important to take note of the following before using the WPS function:
The WPS function of your router must first be enabled before you can
use Wi-Fi Protected Setup.
WPS can only be used with wireless client devices that also have a WPS
feature. You may consult your Wireless client’s user guide to verify if
your device has a WPS feature.
The WPS feature is available both for 2.4GHz wireless clients and 5.0GHz
wireless clients.
To enable or disable WPS function:
1. On the WPS Setup section, choose whether to disable or enable the
WPS.
2. You may also copy the WPS AP Pin for future use.
3. Click the ‘Save/Apply’ button to apply changes.
To Next Page
Loading...
Need help?
General
