User Manual
Hardware Setup
Before you install the router, you should connect your PC to the Internet through your
broadband service successfully. If there is any problem, please contact your ISP. After
that, please install the router according to the following steps. Don't forget to pull out the
power plug and keep your hands dry.
To setup the hardware:
1. Use Ethernet cables to connect the computers in your network into the LAN ports.
2. Use an Ethernet cable to connect the cable/DSL Modem into the WAN port.
3. Connect the AC power adaptor to the AC power socket on the router, and the
other end into an electrical outlet. The router will start to work automatically.
4. Check the LED’s. Power stays on. System, WAN, and LAN 1-4 should remain
flashing. The LED for the LAN port with no connection remains off.
Page 16 of 102
To Next Page
Loading...
Need help?
General
