User Manual
MAC Clone
MAC Clone
You can configure the MAC address of the WAN port on this page:
Some ISPs require that you register the MAC Address of your adapter, which is
connected to your cable, DSL modem or Ethernet during installation. Changes are
rarely needed here.
WAN MAC Address This field displays the current MAC address of the WAN port,
which is used for the WAN port. If your ISP requires that you register the MAC
address, please enter the correct MAC address into this field. The format for the
MAC Address is XX-XX-XX-XX-XX-XX (X is any hexadecimal digit).
Your PC's MAC Address This field displays the MAC address of the PC that is
managing the router. If the MAC address is required, click Clone MAC Address.
Click Restore Factory MAC to restore the MAC address of WAN port to the factory
default value.
Click Save to save your settings.
Note:
1. Only the PC on your LAN can use the MAC Address Clone feature.
2. If you click Save, the router will prompt you to reboot.
Page 44 of 102
To Next Page
Loading...
Need help?
General
