BAIC D50 Series User Manual

104 Lights and views
D50
2
Operation system and specification
Location "0" applies to drivers or drivers and
front row passengers (without luggage)
Location "1" applies to all seats full
Location "2" is suitable for all seats full, and the
luggage compartment distributes load evenly
(reaching the allowable axle load of the rear
axle and not exceeding the maximum allowable
loading mass).
Location "3" applies to the driver and the
luggage compartment distributes load evenly
(reaching the allowable axle load of the rear
axle and not exceeding the maximum allowable
loading mass).
Bend auxiliary lighting
In the course of driving, when the headlamp is
on, the driver turns the steering wheel around
(reaching a certain angle), the fog lamp on the
corresponding side lights up, and assists the
vehicle in driving to illuminate the blind area of
the bend. When the steering wheel is turned
back, the auxiliary lamp on the corresponding
side closes.
Backlight brightness adjustment
Backlight brightness adjustment button
located on the dashboard Multifunctional switch
panel on the lower left.
When the position lamp is lit, the backlight of
each key of the instrument and the whole
vehicle is lit. Pull up the back light brightness
adjustment button, instrument backlight and
vehicle keys back light brightness increased;
Pull down the back light adjustment button,
instrument backlight and vehicle keys back light
brightness decreased. Backlight brightness has a
total of 10 levels. When backlight is adjusted,
the current backlight brightness level will be
displayed on the combined instrument.
Danger warning light switch
The danger warning light switch is located on
the multimedia control panel.
In case of emergencies, use hazard warning
lights to remind other road users to pay attention
to avoid causing traffic accidents.
In the following cases, the danger warning light
should be turned on:
1. When the vehicle breaks down due to
technical failure.
2. The car was at the end of the convoy in a
traffic jam.

BAIC D50 Series Specifications

General

Brand	BAIC
Model	D50 Series
Category	Automobile
Language	English