Lights and views 105
D50
2
Operation system and specification
3. When an emergency.
4. When towing another vehicle or being towed.
When the danger warning light switch is pressed
down, all the steering lights will flicker at the
same time, and the two steering signals in the
combined instrument will also flicker at the
same time.
Even if the start/stop button is in "OFF" mode,
the hazard warning lamp can still work.
If you need to turn off the danger warning light,
press the danger warning light switch again.
Notice
●When the engine is not started, if there is
no special need, do not turn on the danger
warning lamp for a long time, so as not to
cause the battery to lose power.
Emergency Brake Signal
When the speed of the vehicle exceeds 50 km/h
and emergency braking occurs, the brake lamp
will flicker
；
When the vehicle speed exceeds 70km/h,
emergency braking occurs and the emergency
braking continues until the vehicle speed drops
below 10km/h, the brake light flashes and
automatically turns on the danger warning light.
After that, if the vehicle accelerates to a speed
above 20km/h and maintains a speed above
20km/h for more than 5 seconds, the danger
warning light will automatically turn off; You
can also manually turn off the hazard warning
light by operating the hazard warning light
switch.
。
The running light is not turned off
When the start/stop button is in "OFF" mode,
the light switch is at the position light or
near-light light and the vehicle position light is
on. At this time, open the driver's door, and the
instrument will send out an alarm that the
driving light is not OFF.
Interior Lights
Front reading light *
●
Press the switch
，
driver side reading
light is on; After 10 minutes or within this time
Press the switch again reading lamp
out.
●
Press the switch , front passenger side
reading light is lit
；
Turn on the light for 10
minutes or press the switch again
reading lamp out.
To Next Page
Loading...
Need help?
General
