224 Defective wheel replacement
D50
5
Emergency handling
6
Turn the jack assembly clockwise to lift the
vehicle until the wheel is off the ground.
7
Remove the wheel retaining nut, then remove
the faulty wheel, place the external surface of
the faulty wheel in a proper position under the
vehicle, and replace the spare wheel
Warning
●When the vehicle is running, the heat
generated by the braking system will
cause the wheel fixing nut to become hot.
Please be careful of scalding when
removing the wheel
Warning
●Strictly observe the jack operation notes.
●Do not jack up the vehicle other than the
specified support point
●Do not use pad blocks above or below
the jack assembly
●Do not us other jack assembly that not
equipped by this vehicle.
●Do not jack up the vehicle too high.
●In the process of lifting, the vehicle
condition should be constantly observed.
If the vehicle body is perceived to have
obvious tilting or abnormal movement,
the lifting should be stopped, the problem
should be found out, and solved before
Install spare wheel
Warning
●Do not use spare wheels that have been
damaged or worn to the limit. Avoid tires
that are more than 6 years old.
●After the spare wheel is installed, check
the tire pressure and adjust it to the
specified range
●The spare wheel is only used in
emergency. When the spare wheel is
installed, the driver should drive carefully
and the speed should not be higher than
70km/h, to avoid rapid acceleration and
To Next Page
Loading...
Need help?
General
