Defective wheel replacement 225
D50
5
Emergency handling
1. Align the spare wheel to the hub of the wheel
Notice
●Before installing the spare wheel,
remove the dirt from the surface between
the wheel and the brake disc
2. Install all the wheel nuts, tighten all the wheel
nuts by hand first, and then tighten the wheel
nuts by wrench to make sure that the wheel is
fully positioned.
3. Turn the jack assembly handle
counterclockwise and lower the vehicle
Use the wheel nut wrench to tighten the wheel
retaining nut clockwise. Do not use any other
tool, such as hammer or barrel, and make sure
the wrench is completely on the nut.
110±10N·m
。
Tighten the wheel retaining nuts
evenly in the diagonal order shown in figure 1
to 5.The specified torque is 110±10N•m
To Next Page
Loading...
