BAIC D50 Series - Page 226

226 Defective wheel replacement
D50
5
Emergency handling
Warning
●Threads on wheel retaining nuts and
hubs must be kept clean and free from
grease and other attachments.
●The wheel nut must be tightened
correctly according t
o the specified
tightening torque, otherwise the nut may
become loose when the vehicle is driving,
which may easily cause traffic accidents.
●Tighten the wheel nut with the wheel nut
wrench provided by the vehicle, but the
torque value cannot be confirmed. In the
process of driving, control the speed
reasonably to avoid rapid acceleration
and emergency braking, and go to BAIC
service station as soon as possible to check
and ensure that the wheel nut meets the
specified torque.
Notice
●When replacing the wheel, if the nut is
corroded or difficult to screw, the nut
must be replaced or the threaded hole
must be cleaned when checking the
tightening torque of the wheel nut.
●After the spare wheel is installed, go to
Beijing automobile dealership to repair it
as soon as possible. Replace the spare
wheel immediately after the faulty wheel
is repaired.
Return the tool and parts to its position.
●The replaced faulty wheel should be well
placed
●The tools should be cleaned and put back in
place
●Don't forget to retrieve the warning triangle
after changing the wheel.