Instrument and control system 67
D50
2
Operation system and specification
Maintenance information
The maintenance information shows the mileage
that was taken from the next vehicle. The first
maintenance mileage of the vehicle is 5000 km,
and the interval maintenance mileage is 5000
km. It is recommended that users regularly
check and maintain in time. In the maintenance
information display, press and hold the ENTER
button for 30 second store set the maintenance
mileage.
Fault view
When the alarm message is displayed on the
meter interface, the fault information is
automatically stored in the fault view menu.
After selecting “Fault View” in the menu, press
ENTER to view the setting interface, and then
toggle up/down. The button can be used to view
the fault information. If there is no fault, it
displays “no fault”.
Restore Factory
After selecting "Restore factory" in the menu,
press the ENTER button the factory reset. After
entering the factory default interface, toggle
up/down. The key can be selected, short press
the ENTER button to set and return to the menu
interface.
To Next Page
Loading...
Need help?
General
