Baker Panametrics PanaFlow XMT1000 - F.11 Error Handling

PanaFlow™ XMT1000 User’s Manual 123
Appendix F. Foundation Fieldbus Communication
F.11 Error Handling
The flow meter publishes the error status on the Fieldbus along with the real data. The error status can be seen in the
CH_x_Reported Error parameter on the Channel Transducer Block. In addition, the Quality parameter shown with
each of the process variables reports the error. In Figure 77 below, the CH1_REPORTED_ERROR shows as E1.
Note: For more information on the actual measurement errors and possible causes, see Chapter 4, Error Codes
and Troubleshooting.
Figure 77: Reported Error