PanaFlow™ XMT1000 User’s Manual 51
Chapter 3. Programming
Figure 44: Fluid Programming
3.6.3 Programming the Path Configuration
Use steps as in section “Log-in and Primary Pages” to navigate to the Programming page. Refer to Figure 45 for the
Path configuration options.
1. Highlight [Composite] and press [ENTER]. Scroll down and select [Path] and press [ENTER].
2. Select [Path Configuration], [Path Weights] and [Path Error Handling].
3. Path Weights are used in Composite flow velocity calculations as in the following equation:
Table 19: Standard Fluid List
Tracking On Tracking Off
Other Other
Water (0 to 260 C) Water (0 to 260C)
LNG LNG
Oil 22C Oil 22 C
Sea Water
Lube Oil
Crude Oil
Methanol (20 C)
Ethanol
Freon R12
Diesel
Gasoline
Liquid Nitrogen (-199C)
To Next Page
Loading...