PanaFlow™ XMT1000 User’s Manual 79
Appendix A. Specifications
Appendix A. Specifications
A.1 Operation and Performance
Fluid Types
Liquids: acoustically conductive fluids, including most clean liquids, and many liquids with small amounts of
entrained solids or gas bubbles.
Transducer Types
All liquid wetted and clamp-on transducers.
Pipe Sizes
Standard: 1 in. to 76 in. (25 mm to 1930 mm)
Optional: >76 in. (1930 mm) consult factory
Data Logging
Storage standard on meter, up to 10,000 flow date points with 26 parameters per data point (required PanaView
TM
Plus software)
Note: Please see other operation and performance criteria with the PanaFlow HT, PanaFlow Z3, PanaFlow LZ, and
PanaFlow LC flowmeter system manuals.
Measurement Parameters
Volumetric Flow, Mass Flow, Flow Velocity and Totalized Flow
Flow Accuracy (Velocity)
Up to ±0.3% of reading (achievable when supplied with a complete flow meter system and process calibration).
Accuracy depends on pipe size, installation and number of measurement paths.
Note: The accuracy statement assumes measurement of a single phase homogeneous liquid with a fully
developed symmetrical flow profile passing through the meter. Applications with piping arrangements that
create an asymmetrical flow profile may require extended piping straight runs and/or flow conditioning for
the meter to perform to this specification.
Repeatability
±0.1% to 0.3% of reading
Range (Bidirectional)
–40 to 40 ft/s (–12.2 to 12.2 m/s)
Meter Turndown
400 : 1
Optional PC Software
PanaView
TM
Plus software for added functionality
To Next Page
Loading...