Baker Panametrics PanaFlow XMT1000 - 3.4 Main Program - System Settings

PanaFlow™ XMT1000 User’s Manual 31
Chapter 3. Programming
3.4 Main Program - System Settings
3.4.1 Selecting Units
The operator can select the preferred units of measurements. Use steps as in section “Log-in and Primary Pages” to
navigate to the System settings page. Then highlight [Unit Settings] and press [ENTER], you will now have
measurement types listed as in the Figure 28 below, for which you can select your preferred respective units.
Figure 28: Selecting Units
3.4.1.1 Supported Unit Groups and Units
The Table 3 specifies the unit groups and its respective units supported in XMT1000.
Table 3: Unit groups and supported units
Unit Group Supported Metric Units Supported English Units
Velocity Units m/s ft/s
Volumetric Units m³/s, m³/min, m³/h, m³/d, L/s, L/min,
L/h, ML/d
ft³/s, ft³/min, ft³/h, ft³/d, gal/s, gal/min, gal/h,
gal/d, bbl/s, bbl/min, bbl/h, bbl/d, kgal/min,
kgal/h, kgal/d, kbbl/min, kbbl/h, kbbl/d,
ac-ft/min, ac-ft/h, ac-ft/d, ac-in/s,
ac-in/min, ac-in/h, ac-in/d, impgal/s,
impgal/min, impgal/h, impgal/d, Mbbl/d,
Mimpgal/d, Mgal/d
Standard Volumetric Units SL/s, SL/min, SL/hr, SL/d, Sm³/s,
Sm³/min, Sm³/hr, Sm³/d
SCFH, SCFM, SBBLD, SBBLH, SBBLM, SBBLS,
SCFD, SCFS
Mass Units kg/s, kg/min, kg/h, kg/d, Ton/s,
Ton/min, Ton/h, Ton/d
lb/s, lb/min, lb/h, lb/d, klb/s, klb/min, klb/h,
klb/d, STon/s, STon/min, STon/h, STon/d
Volumetric Totals Units m³, L, Sm³, SL, ML, Mm³ ft³, Mft³, gal, Mgal, bbl, Mbbl, ac-ft, ac-in,
impgal, Sft³
Mass Totals Units kg, MTon Lb, STon
Dimension Units mm in
Density Units kg/m³, g/cm³, Ton/m³, kg/L, g/mL,
kg/dm³
oz/in³, lb/in³, lb/ft³, lb/gal
Pressure Units
kg/m
2
, Pa, MPa, KPa, bar, mBar, Torr,
atm
Psi-g, Psi-a
Angle Units Degree, Radians Degree, Radians