7．EtherNet/IP Connection Procedure
Precautions for Correct Use
If the Ports 0-7 statuses of the Network Module are different from the ones described in step
9, go back to step 13 of 7.4.2. Uploading the Network Configuration. Check and change the
device parameters for the Ports 0-7 functions of the Network Module.
After changing the device parameters, delete the already set connections by following the
steps below, and then follow each step of 7.4.4. Setting Connections and the subsequent
procedures again.
Note that changed device parameters of the Network Module are not reflected unless you
retransfer the tag data link parameters to the Controller after deleting the already set
connections and setting them as new ones again.
■How to delete the connections
(1)Right-click the device icon of Controller (Node 1) in the Network Configuration Pane and
select Parameter - Edit from the menu.
(2)Click the Connections Tab in the Edit Device Parameters Dialog Box.
(3)Select 192.168.250.2 from the Register Device List and click .
To Next Page
Loading...
