If the IODD of the IO-Link device on the currently selected port has parameters, these are
shown in table format (see following screenshot). In this example the parameters for the
Balluff Smart Light are shown.
The Smart Light is a signal light which can be used in three different modes. These modes
can be set using an IO-Link parameter. The parameter values and associated texts are
stored in the IODD.
This means "Operation Mode" can be read out and displayed ("Read" and "Read All"
buttons) or written to the device ("Write" button).
If subindexes have no buttons they cannot be individually processed but rather only the
entire index at once.
To Next Page
Loading...
