Events are classified using the "Severity“ column:
Internal Error (Emergency, Alert, Critical)
The fieldbus module has detected a fault in itself (hardware or software) which should
not occur during normal operation. If this happens, the module must be serviced or
replaced.
External Error (Error, Warning)
The fieldbus module has detected what may be a non-permissible event which is
affecting the module from the outside. The system may require troubleshooting.
Event (Informational, Notice)
The fieldbus module has detected an important normal operating event and reports it.
These may include for example configuration actions over the web interface and other
configuration interfaces which are also recorded.
Clicking on "Set Module Time” sends the current browser time to the fieldbus module but
does not permanently store it. After a reset, reboot or loss of power the time begins to run
again from the year 2000.
Clicking on "Update Log” refreshes the display, and "Clear Log” deletes all entries. The log
entries are stored in a ring buffer.
To Next Page
Loading...
