The BNI CIB-Module is used as a remote I/O module and/or IO-Link module for connecting
to a CC-Link IE Field Basic network.
Attention!
Installation and startup are to be performed by trained technical personnel only.
Skilled specialists are people who are familiar with the work such as installation
and the operation of the product and have the necessary qualifications for these
tasks. Any damage resulting from unauthorized tampering or improper use shall
void warranty and liability claims against the manufacturer. The operator is
responsible for ensuring that the valid safety and accident prevention regulations
are observed in specific individual cases.
Commissioning and inspection
Before commissioning, carefully read the User's Guide.
The system must not be used in applications in which the safety of persons depends on the
function of the module.
Authorized personnel
Installation and startup must only be carried out by trained technical personnel.
Intended use
Warranty and liability claims against the manufacturer are rendered void by:
• Unauthorized tampering
• Improper use
• Use, installation or handling contrary to the instructions provided in this user's guide
Obligations of the owner/operator!
The module is a piece of equipment in accordance with EMC Class A. This module can
produce HF noise. The operator must take appropriate precautionary measures. The module
may only be used with an approved power supply. Only approved cables may be connected.
Malfunctions
In the event of defects and device malfunctions that cannot be rectified, the module must be
taken out of operation and protected against unauthorized use.
Intended use is ensured only when the housing is fully installed.
Resistance to
aggressive
substances
Attention!
The BNI modules always have good chemical and oil resistance. When used in
aggressive media (such as chemicals, oils, lubricants and coolants, each in a high
concentration (i.e. too little water content)), the material must first be checked for
resistance in the particular application. No defect claims may be asserted in the
event of a failure or damage to the BNI modules caused by such aggressive media.
Attention!
Before working on the device, switch off its power supply.
Note
In the interest of continuous improvement of the product, Balluff GmbH reserves
the right to change the technical data of the product and the content of these
instructions at any time without notice.
To Next Page
Loading...