B&G Network QUAD - Setting the Depth Units

19
The Network QUAD unit can be set to display depth in
Metres, Feet or Fathoms. The selected units are used for
displayed depth information on all Network instruments on
the entire Network system.
Press DEPTH
key to display the
current depth.
Press SETUP key
twice. The depth
display will go
blank.
Press ENTER
key if the units
are to be
changed.
Use ! or " to
change the units.
Press ENTER
key to memorise
the change.
Press DEPTH to
display current
depth.
SETTING THE DEPTH UNITS