Bandit 20XP - Page 17

Bandit
15Copyright 12/17
MODEL 20XP DECALS
DECAL LOCATIONS
Modications and/or additions of decals to this list will happen.
Consult chipper dealer or manufacturer for most current decal package.
LOCATION NUMBER DESCRIPTION
Some decals are for optional equipment. Decal locations may vary, these are general
locations. If any decals become damaged, replace immediately.
NOTICE
1. SPD-01 Avoid Injury Or Death...
2. SPD-02 Moving Parts...
3. SPD-03 Lockout All Energy Sources...
4. SPD-04 Flying Discharge Material...
5. SPD-16 Do Not Hand Feed...
6. SPD-18 Never Perform Maintenance
7. SPD-20 Flying Objects Stand Clear...
8. SPD-28 Do Not Insert Fingers
9. SPD-30 Do Not Sit, Stand, Lay, Climb...
10. SPD-32 Do Not Operate This Machine...
11. SPD-33 Do Not Work Under...
12. SPD-52 Never Open Bottom Clean-Out Door...
13. SPD-53 ...Always Use Some Sort Of Mechanical Device...
14. SPD-62 Stay Clear...Tongue Jack
15. ID-67 Bandit Industries Inc...USA
16. INST-02 Yoke Lock Hole
17. INST-03 Yoke Lock Bar
18. INST-04 Arrow
19. INST-10 Stabilizer Up / Down
20. INST-11 Motor Coupler Guard...
21. INST-12 Grease Daily (Arrow)
22. INST-16 Grease Weekly Arrow
23. INST-39 Oil Daily Arrow
24. INST-44 California Proposition 65
25. INST-46 Autofeed Basic Info...
26. INST-48 Disc/Drum Lock Tube
27. INST-49 Disc/Drum Lock Pin
28. INST-53 Hydraulic Oil...Hydrex XV...
29. INST-90 Tongue Up / Tongue Down
30. INST-95 Electric Plug-In Schematic
31. INST-101 Canada Engine Decal
32. INST-109 Basic Maintenance Check List
33. INST-137 Remote / Tether
34. INST-199 Grease Axle Torsion Arm Bushing...
35. INST-276 Test Trailer Brake System
36. INST-294 Bandit Control System
37. INST-346 Purge Cutter Head Bearings
38. N-02 Maintain Lubrication...
39. N-03 Service Required Under Beltshield...
40. N-05 Frequently Adjust...PTO...
41. SPN-06 Decal Maintenance...
42. N-07 Clutch Operation...
43. N-09 Adjustable Feed Speed...
44. SPN-11 Correct Knife And Hardware...
45. N-69 Patents...