There are two air vents on each side of the drum housing of your machine. The air vents can be opened
or closed to adjust the chip throwing to your particular application. The chip throwing distance has many
variables for example: type of material chipping, size of material chipping, the machine engine size, if machine
is equipped with autofeed or not, etc.
Before adjusting the air vents; disengage clutch, wait for the disc/drum to come to a complete stop,
turn o engine, remove the ignition key, make sure the ignition key is in your possession, install the
disc/drum lock pin, and disconnect the battery.
The vent cover can be bolted on or removed from the drum housing, depending on your needs. There is
one vent cover on each side of the drum housing. The beltshield may have to be removed on some machines,
depending on model and options, to access the vent cover on the right side.
The sliding air vent can be adjusted by loosening the knob and moving the vent to the open or closed
position. There is one on each side of the drum housing.
To Next Page
Loading...
