ADVANCED OPERATION
7. FUNCTION "VOX" (VOICE OPERATED TRANSMISSION)
This function is not necessary to push the [PTT] on the transceiver for a
transmission. Transmission is activated automatically by detecting the radio voice.
When finish speaking, the transmission automatically terminated and the transceiver
will automatically receive signal. Be sure to adjust the VOX Gain level to an
appropriate sensitivity to allow smooth transmission. To enable or disable this
feature, follow the steps below:
1. Press the [MENU], then press [UP]/[DOWN] to select the Menu 07 "VOX"
2. Press [AB/], then press [UP]/[DOWN] to select OFF/1/2/3/4/5/6/7/8/9.
3. Press [AB/] to save the setting.
4. Press [MENU] or any numeric key to exit.
Note:
- Levels 7 to 9 are most sensitive, is used in quiet environments.
- Levels 4 to 6 are medium-speed, is used in normal environments.
- Levels 1 through 3 are less sensitive, is used in high ambient noise conditions.
8. FUNCTION "BEEP" KEYPAD
When activated, you will hear a "beep" each time you press a key on the transceiver.
If you select "OFF" will not hear any "beep". To enable or disable this feature, follow
the procedure outlined below:
1. Press the [MENU], then press [UP]/[DOWN] to select the Menu 08 "BEEP"
2. Press [AB/], then press [UP]/[DOWN] to select OFF/ON.
3. Press [AB/] to save the setting.
4. Press [MENU] or any numeric key to exit.
9. VOICE PROMPT "VOIC"
To select the desired language of voice prompt, please follow as the steps:
1. Press the [MENU], then press [UP]/[DOWN] to select the Menu 09 "VOIC"
2. Press [AB/], then press [UP]/[DOWN] to select OFF/ON.
To Next Page
Loading...
