R5900049 /07 ClickShare CSE-800 87
Image 6-34
Necessary Data to continue:
Domain The company domain for which you are enrolling, should match with the one defined
in your Active Directory.
Identity Identity of the user account in the Active Directory which will be used by the
ClickShare Buttons to connect to the corporate network.
Password The corresponding password for the identity that you are using to authenticate on the
corporate network. Per Base Unit each Button will use the same identity and
password to connect to the corporate network.
Corporate SSID The SSID of your corporate wireless infrastructure to which the ClickShare Buttons
will connect.
Click Next to continue.
When having problems connecting the Button to your corporate network, to get feedback from the Button
please have a look at the ClickShare Client log. This log can be enabled by holding the Shift key when starting
the Client executable. Look for the lines “EDSUSBDongleConnection:: mpParseDongleMessages”. An error
code and a short summary of the issue should be logged.
6.17 Network integration, WPA2-PSK security
mode
About WPA2-PSK
WPA2-PSK does not distinguish between individual users, there is 1 password (PSK – Pre-Shared Key) for all
clients connecting to the wireless infrastructure. This makes setup very straightforward. Once connected, all
data transmitted between client and AP (access point) is encrypted using a 256 bit key.
How to start up for WPA2-PSK
1. Log in to the Configurator.
2. Click WiFi & Network → Network integration. Click on Change configuraton.
3. Select the radio button next to WPA2-PSK and click Next.
CSE-800 Configurator
To Next Page
Loading...
