R5900049 /07 ClickShare CSE-800 81
Image 6-26: Network integration, activation
A setup wizard starts up.
Apps
To allow mobile devices connected to the corporate network to share content with any Base Unit on the
network, you need enable those via the Wi-Fi & Network > Services page of the Configurator. Make sure the
proper Services are enabled and the Enable over LAN box is checked.
You must re-pair all the Buttons after completing the setup wizard !
6.14 Network integration, EAP-TLS security mode
About EAP-TLS
EAP-TLS (Transport Layer Security) is an EAP method based on certificates which allows mutual
authentication between client and server. It requires a PKI (Public Key Infrastructure) to distribute server and
client certificates. For some organizations this might be too big of a hurdle, for those cases EAP-TTLS and
PEAP provide good alternatives. Even though a X.509 client certificate is not strictly required by the standard
it is mandatory in most implementations including for ClickShare. When implemented using client certificates,
EAP-TLS is considered one of the most secure EAP methods. The only minor disadvantage, compared to
PEAP and EAP-TTLS, is that the user identity is transmitted in the clear before the actual TLS handshake is
performed. EAP-TLS is supported via SCEP or manual certificate upload.
How to start up for EAP-TLS
1. Log in to the Configurator.
2. Click WiFi & Network → Network integration. Click on Change configuraton.
3. Select the radio button next to EAP-TLS and click Next.
CSE-800 Configurator
To Next Page
Loading...
Need help?
General
