R5900049 /07 ClickShare CSE-800 89
About streaming information via AirPlay
Before you can stream information and display it via ClickShare your device must be connected with the
wireless network of the Base Unit. Then AirPlay must be activated on your device. For more information about
activating AirPlay, consult the user guide of your device.
The supported versions of AirPlay can be found on Barco’s website, www.barco.com\clickshare. The support
of non-released version of these protocols cannot be guaranteed by Barco.
About streaming via Google Cast
Before you can mirror information and display it via ClickShare your device must be connected with the
wireless network of the Base Unit. When activating Google Cast on your device an overview of the access
points is given. For more information about using Google Cast, consult the user guide of your device.
The supported versions of Google Cast can be found on Barco’s website, www.barco. com \clickshare. The
support of non-released version of these protocols cannot be guaranteed by Barco.
Google Cast does not support a passcode.
Google Cast can only be used when the clock of the Base Unit is set correctly. If not Google Cast
cannot make a connection with the Base Unit.
How to enable
1. Log in to the Configurator.
2. Click WiFi & Network → Services.
Image 6-37: Services, mobile devices
3. To allow any of the services over the wired ethernet connection, check the box in front of Enable over LAN.
To allow sharing content via ClickShare app, check the check box in front of Sharing via ClickShare app.
To allow streaming via AirPlay, check the check box in front of Streaming via AirPlay.
To allow streaming (mirroring) via Google Cast, check the check box in front of Streaming via Google Cast.
4. To add a passcode, click on the drop down and select the desired passcode (not for Google Cast).
The following options are possible:
• No passcode
CSE-800 Configurator
To Next Page
Loading...
Need help?
General
