48 CLM W6
5. Appendices
Image is out of focus
Make sure the lens cap is removed.
Adjust lens focus to t.
Make sure the projection screen is between the required distance.
The image is stretched when displaying 16:9 DVD title
When you play anamorphic DVD or 16:9 DVD, the projector will
show the best image when the projector display mode is set to 16:9
in the OSD.
If you play 4:3 format DVD titles, please change the format to 4:3 in
the projector OSD.
If the image is still stretched, you will also need to adjust the aspect
ratio by referring to the following:
Please setup the display format as 16:9 (wide) aspect ratio type on
your DVD player.
Image is too small or too large
Adjust lens zoom to t. If it does not ll the screen properly, please
change the correct lens or change the position of the projector.
Image has slanted sides
Reposition the projector so that it is perpendicular to the screen.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may make
a loud popping sound. If this happens, the projector will not turn on
until the lamp module has been replaced.
-
-
-
-
-
-
-
-
-
-
To Next Page
Loading...
Need help?
General
