Barco MXRT-7600 - Operation; Configuration; I-Luminate; Description

K5905271 /16 Display Controller
35
5.7.2 Operation
Using FindCursor
To quickly locate the cursor, hold down the hotkey (default: Control +Shift +F). The cursor location will be
highlighted by a circle, which appears yellow on color displays and gray on grayscale displays.
5.7.3 Configuration
Configuring FindCursor
• Enable/Disable: Use the checkbox to enable or disable FindCursor.
• Hotkey: The currently selected hotkey is displayed in the edit box. To program a new hotkey, highlight the
edit box, and input the new keystrokes. The change will take affect right away.
5.8 I-Luminate™
I-Luminate is pending medical device clearance and is currently not available in all markets.
5.8.1 Description
Overview
This feature boosts the luminance of supported displays.
Image 5-9
Supported display controllers
When driven by an MXRT-x400 or later display controller, I-Luminate can be enabled on supported displays,
including MDMC-12133, MDMG-5221, and MDCG-5221.
5.8.2 Operation
Using I-Luminate
A hotkey will boost the luminance on all selected displays.
5.8.3 Configuration
Configuring I-Luminate
• Enable I-Luminate for these displays: All displays that support I-Luminate are listed in the configuration
section. Click on the checkbox to enable the feature on that display.
• Hotkey to enabled I-Luminate: Click Clear to remove a hotkey. Click on the hotkey box to enter a new
one.
• Timeout: The slider bar sets the time-out period for the I-Luminate mode.
Driver and Intuitive Workflow Tools