Barco MXRT-7600 - Singleview; Description; Operation; Configuration

K5905271 /16 Display Controller
38
5.11 SingleView™
5.11.1 Description
Overview
SingleView enables the use of a Coronis Fusion display as a single display in the Windows desktop and
eliminates any tearing down the center.
Image 5-12
Supported displays
When driven by an MXRT-x400 or later display controller, SingleView is supported on all Coronis Fusion
displays.
5.11.2 Operation
Using SingleView
A button will switch all Coronis Fusion displays into SingleView, and another will switch all into DualView.
Hotkeys are available for both actions.
When in SingleView, it is possible to have the left and right halves out of position, and a button will swap the
two.
DualView is the preferred setting for most PACS application software.
5.11.3 Configuration
Configuring SingleView
• Enable SingleView: This check box will toggle between SingleView and DualView.
• Swap Left/Right: This can correct misaligned SingleView displays one at a time.
• Hotkeys: SingleView and DualView activations have individual hotkeys. Click Clear to remove a hotkey.
Click on the hotkey box to enter a new one.
5.12 SmartCursor™
5.12.1 Description
Overview
The Barco SmartCursor feature prevents the cursor from becoming stuck on edges of adjacent displays of
different sizes.
Image 5-13
Supported display controllers
SmartCursor is supported by all systems with an MXRT-x400 or later display controller.
Driver and Intuitive Workflow Tools