K5905271 /16 Display Controller
40
5.13.3 Configuration
Configuring SoftGlow
• Task Light and Wall Light: Use these sliders to set the brightness of the lights. Click and enter 0 to shut
the light off.
• Hotkey: When configured, this hotkey will toggle the task lights on and off. The wall lights are only
controlled by the slider.
5.14 SpotView™
SpotView is pending medical device clearance and is currently not available in all markets.
5.14.1 Description
Overview
The SpotView feature allows focused observation during readings by dimming images outside a region of
interest and optionally enhancing the contrast in the region of interest.
The SpotView Mag feature offers 2x zoom within the SpotView region of interest. SpotView Invert inverts the
pixels in the region of interest. SpotView Align creates a bar-shaped region of interest, which can be rotated as
needed. SpotView Align has 2 modes of operation, a straight bar, or a V-shaped bar.
Image 5-16
Supported displays and display controllers
When driven by an MXRT-x500 or later display controller, SpotView can be enabled on selected Barco
Coronis, Nio, and Mammography displays, including MDCC-6530, MDCC-6430, MDCC-6330, MDCC-4430,
MDCC-4330, MDCC-4230, MDCG-5221, MDCG-3221, MDNC-6121, MDNC-3421, MDNC-3321, MDNC-
2221, MDNG-5221, MDMG-5121, MDMG-5221, MDMC-12133.
5.14.2 Operation
Using SpotView
SpotView highlights a region of interest. The region of interest is selected by the use of the Barco Touchpad or
by the mouse and a hotkey (default: Control+Shift+X). To control SpotView with the touchpad, hold and move
one finger. The highlighted region of interest is always bound to displays that support SpotView.
To show SpotView when the Barco Touchpad is in Mouse Emulation Mode, hold one finger then tap
a second.
The default diameter of the region of interest is controllable in the Barco System Settings Control Panel. If
Dynamic Sizing is enabled, the diameter is also controllable with the scroll wheel when using the mouse, or
with a pinch gesture when using the Barco touchpad. When SpotView is released, it returns to the default
diameter on the next activation. When using the mouse, clicking on the scroll wheel will toggle between
controlling the Dynamic Sizing of the spot and scrolling in the Windows application.
To enhance viewing on Coronis and Mammography displays, the SpotView feature boosts the luminance of
the display, if supported. The boost feature will turn off after one minute of continuous use. To further enhance
viewing, the SpotView feature will optionally enhance the contrast of the region of interest. Contrast
enhancement is not available with SpotView Align.
Driver and Intuitive Workflow Tools
To Next Page
Loading...
