Display Controller installation
System manual Nio 5MP 29
6. Connect the primary display to the connector marked
“VID 1” on the BarcoMed Nio display controller
using the provided DVI cable (see figure 7). For a
dual-headed BarcoMed Nio setup, connect the
secondary display to the other connector on the
display controller.
7. Reconnect the power cord, turn on the power, and
boot the system as usual.
Running multiple BarcoMed Nio Display Controllers
in a single host
The physical order of the displays may vary when you
are running multiple BarcoMed Nio display controllers.
This is due to the PC’s PCI bus control in the system
BIOS, and not the BarcoMed display controller. It may
become necessary, depending on how your PC’s BIOS
configures the PCI bus, to switch your DVI display
connections to achieve a linear desktop configuration.
Figure 7
To Next Page
Loading...
