Display Controller installation
28 System manual Nio 5MP
Figure 6: PCI and RAID Controller Slots
Installing the BarcoMed Nio display controller
Install the BarcoMed Nio controller in your computer
following these steps:
1. Turn off the power to your computer and disconnect
the power cord, however make sure that the
computer chassis is still grounded.
2. Remove the chassis cover according to the
manufacturer’s instructions. Be sure to observe
safety warnings.
3. If you have decided to use the on-board VGA
capabilities of the BarcoMed Nio controller (see
“Using the VGA capabilities of the BarcoMed Nio
display controller” on page 26), you must now
remove any VGA controllers that are currently
installed in the computer.
4. Install the BarcoMed Nio display controller into a free
PCI slot, either 32 bit or 64 bit (see figure 6 above,
for examples of slots). Be sure that the display
controller is seated firmly in the slot.
5. Secure the card to the chassis with the PC’s I/O panel
mounting screw, and replace the chassis cover.
To Next Page
Loading...
