Software installation
System manual Nio 5MP 51
you will need to rerun the installer to install the
drivers for the other devices.
If you select a device with an installed driver, the
wizard will warn you if the installed driver is newer
than the one you are installing (figure 27).
Figure 27
Click “OK” to install the new driver. If you don’t want
to replace the exiting driver, click “OK” and then
click “Cancel”.
7. Your selection on the “Enable DualView” screen
determines if DualView is enabled or not. If you wish
to enable DualView “check” the checkbox next to
“Enable the DualView device?”, and click “Next”.
If you do not wish to enable DualView leave the
checkbox empty and click “Next” to continue.
8. The “Device Confirmation” screen displays the device
driver that will be installed. If you want to change
your selection, click “Back” to return to the Device
Selection Screen. Click “Next” to begin installing the
driver. Click “Cancel” to abort the driver installation.
Caution: Once you click “Next”, you cannot cancel
the driver installation.
Prior to beginning the installation the BarcoMed
Driver Install Wizard will warn you that while the
driver is being installed your display may flicker. Click
“OK” to continue.
To Next Page
Loading...
