Bard Site-Rite 5 - ­­­Adjusting­the­scanner; ­­­Attaching­the­power­source­and­charging­the­battery

19
Instructions For Use
2.4 Adjusting the Scanner
2.5 Attaching the Power Source and Charging the Battery
Tension Adjustment Tilt and Swivel Adjustment
When the Site~Rite 5 System is attached to AC power, the battery charges automatically.
Caution: Attach power source in such a way as to prevent damage. Improper installation may damage power cords.
Warning: Use only the combination Site-Rite A/C adapter and
battery charger to charge Site-Rite 5. Use of any other device to
charge Site-Rite 5 battery packs may damage the battery packs and
will void your warranty.
Warning: Only connect a Site-Rite 5 combination A/C adapter
and battery charger to the Site-Rite 5 System. Use of any other
A/C adapter may cause intermittent or unpredictable operation,
may damage the system and will void your warranty.
Warning:
Always properly dispose of dead battery packs in
accordance with local regulations. Improper disposal may present
an environmental hazard.
Warning:
Inspect A/C adapter and battery cord for damage. If
any of the prongs are damaged, use battery power until replace-
ment cord is obtained.