The B1290 will prompt you for the next entry.
B1290: Alarm One is...
Repeat the above steps to record the alarm message, e.g. power failure.
YOU:
2**
B1290: beep-beep
YOU: Power Failure
B1290: Alarm One is Power Failure.
Repeat the above steps until you are satisfied with the way the message
sounds. Then continue.
YOU:
**
B1290: Alarm Two is...
Enter the voice message associated with the second alarm point, e.g. intru
-
sion alarm.
YOU:
2**
B1290: beep-beep
YOU: Intrusion Alarm
B1290: Alarm Two is Intrusion Alarm.
YOU:
** Next
B1290: Alarm Three is...
Repeat the above steps until all the alarm points have been programmed.
When you have entered all the voices, enter Quit (#ÞÞ) at the announce
-
mentof thenext emptyalarm. Ifyou useall eightalarms, theB1290 willau
-
tomaticallyadvance afteryou enter the last voice message. Thenext stepin
the startup process is to program the telephone numbers.
YOU:
#**
Telephone Numbers
B1290: Program Directory
B1290: Directory A, Line One is Radio Alert Voice. (default)
The B1290 has just spoken the actions that will occur from the commands
on the first line in Directory A. The default radio announcement will now
bereplacedwith aphonecall-outcommand. Enter2toindicate youwantto
program the line with new commands.
YOU:
2** Change line
20 Getting Started
To Next Page
Loading...