Appendix A - Programmable Features
Alarm Messages Unique Site ID plus individual messages for
each input. Message length is variable
Alarm Polarity Selects NO or NC input format
Alarm Latch Latches fleeting alarm inputs
Alarm Debounce Selects the delay time before a change of
state on the input is valid. Range is 0.1 to
19.9 in either seconds or minutes
Alarm Directory Selects one of four directories that contain
command actions to be taken when the
alarm is active.
Interval Timer Two stage timer that uses ‘A’ interval ‘A’
times before switching to ‘B’ interval. Both
‘A’ and ‘B’ interval are adjustable up to
249 minutes.
Acknowledge Code Stops the reporting sequence: 1 to 8 digits
Interrogate Code Speaks alarms and relay state: 1 to 8 digits
Alarm On/Off Output Codes Sent when an alarm becomes active (on) or
when it returns to normal (off). Different
codes for each alarm. 1 to 8 digits
Remote Alarm Input Codes Simulate an alarm condition when received.
Different codes for each alarm. 1 to 8 digits
Directory Control Code Changes the alarms to use different direc-
tories; also referred to as shift change.
Two modes are available: one where all
alarms are assigned to Directory A and can
be controlled to alternately use the other
three directories and another where
Directory A alternates with Directory B and
Directory C alternates with Directory D.
Directory Commands Each directory can have up to 20 lines of
command sequences. The commands are
executed when an alarm using the directory
is active. The commands are:
4Dial - phone the programmed number.
4Voice - Speak the alarm messages
4Radio - turn on the radio transmitter
4Wait - Insert a pause: 1 to 249 seconds.
42 Tone - send a two tone page
45 Tone - send a five tone page
73 Appendix A - Programmable Features
To Next Page
Loading...