Barnett Engineering ProTalk Plus B1290 - Acknowledge Code

B1290: beep
Details on how directory commands are entered are shown in Program
Code 2 Directories. The startup process described here provides only the
basic auto-dialer configuration.
Enter the phone number using the pushbuttons on your telephone. The
entry shownbelowwill result intheB1290dialingthe selected numberand
then speaking the alarm messages. The #0 at the beginning is the DIAL
command, followed by a #8 command for VOICE.
YOU:
#0 2559544 #8 **
B1290: Directory A, Line One is DIAL 2559544 VOICE.
Ifthereis anerrorin theentry,hitthe programcode2 followedbyÞÞ and
try again. If the sequence is played back correctly, hit the enter code.
YOU:
** Next
B1290: Directory A, Line Two is empty
The B1290 is prompting you for the second directory line. The commands
entered for line 2 are what will occur if there is no acknowledgement after
the first line commands are completed during operation.
YOU:
2** Change line
B1290: beep
YOU:
#0 2552343 #8 **
B1290: Directory A, Line Two is DIAL 2552343 VOICE.
YOU:
**
B1290: Directory A, Line Three is empty.
TheB1290 is promptingyoufor athirdtelephone number todialif itcannot
getanansweratthefirsttwo. Continueenteringtelephonenumbersuptoa
maximum of twenty. If you are not using twenty numbers, enter the Quit
code (#) at the prompt. If you hit the Enter code (ÞÞ) for an empty tele
-
phone number, the B1290 assumes that you have no more telephone num
-
bers to enter and will jump to the next function.
YOU:
**
or
YOU:
#**
Acknowledge Code
B1290: Program Acknowledge Code.
21 Getting Started