Barnett Engineering ProTalk Plus B1290 - Squelch Polarity; Relay Voices; Acknowledge Request

1** Pulse dialing
** Next
Default: 0 (tone dialing)
Squelch Polarity
This setting changes the polarity of the signal used to indicate a busy radio
channel.
B1290: Squelch is …
YOU:
0** Busy when the input is low
1** Busy when the input is high
** Next
Default: 0 (transmit on high)
Relay Voices
Thissettingenables or disablestheB1290’sspoken response toarelayoper-
ation. If the B1290 is used in a control situation where monitoring the relay
operation is not required, the B1290 would be programmed with the relay
voicesmuted. TheB1290 relayvoices shouldbe enabled whereverification
of a relay operation is required.
B1290: Relay is ...
YOU:
0** Relay voices are not used
1** Relay voices are used
** Next
Default: 1 (voices on)
Acknowledge Request
Thissetting enablesor disables theB1290’s voiceprompt Enter Acknowledge
Code. If thealarm announcementis overapublic addresssystem, forexam
-
ple,acknowledgmentisnot possible. TheB1290wouldbe programmed for
automatic acknowledge (see Interval Timer B, Program Code 4) and there
-
quest for an Acknowledge Code would be disabled.
The B1290 will continue transmitting its alarms until it receives some form
ofacknowledgment,automaticor otherwise,evenifitdoesnotrequestone.
B1290: Acknowledge Voice is …
41 Program Codes