Programming Reference
The ProTalkPlus iscapable of performingmany functions otherthan those
setby its defaultvalues. If yourequire theseextended capabilities,they are
accessed through the program codes. If the default operation of the unit as
described in the Getting Started chapter of this manual is sufficient, then
you may ignore this section.
This chapter organizes the programming parameters by their functions.
See the chapter on Program Codes for more detail on the use and meaning
of the referenced parameters.
1. Alarm Announcement
This section identifies all of the parameters that determine WHAT is sent
when an alarm occurs. By programming these parameters, you may send
voice, signaling, and paging tones.
Directory Used (Program Code 5.2)
Directories (Program Code 2)
Record Alarm Voices (Program Code 1.1)
Alarm On/Off Output Codes (Program Code 3.4)
Acknowledge Request (Program Code 6)
Speak Messages (Program Code 2)
2. Alarm Operation
Thissectionidentifies alloftheparametersthat determineWHENanalarm
will be announced. By programming these parameters, you control when
an alarm is recognized and announced by the ProTalk Plus.
Alarm Format (Program Code 5.1)
Alarm Delay Timebase (Program Code 5.1)
Alarm Debounce (Program Code 5.1)
Interval Timer A (Program Code 4)
Interval Timer B (Program Code 4)
Cycles Through Timer A (Program Code 4)
45 Programming Reference
To Next Page
Loading...