Site Voice Enable
This setting enables or disables the announcement of a site ID from the ex
-
pander unit. If the expanderis beingused to increasethe numberof alarms
to be reported from a single site, you probably don’t need to announce the
siteID again. However, thesite IDmight beuseful to differentiate between
alarms from different areas or pieces of equipment.
B1290: Expander Site is...
YOU:
0** Site voice is not used
1** Site voice is used
** Next
Default: 0 (expander site ID disabled)
To program the parameters within the expander, the PGM port on the
B1290 is used. Programming is done exactly as though the main unit itself
was being programmed, except that the expander number precedes the
programcode. Refer toExample 10-Addingan Expanderfora specific de-
scription of this procedure.
Program Code 8 ÞÞ: Reset Database
This code is used to reset all of the programmed parameters (excluding
voices) to their default values.
B1290: Enter Empty Code
YOU:
#31** Clear Database
** Next
Any other entry will leave the database unchanged.
Program Code 9 ÞÞ: Audio Levels
This code is used to adjust audio levels for specific signals. For receive lev
-
els the setting should correspond to the level of the signal that is coming
from the attached equipment. Receive levels can be in the range between
-20 dBm and 0 dBm. For transmit levels the setting determines the ampli
-
tudeofthesignalthatwill beproduced at theoutput ofthe B1290. Transmit
levels can be set in the range between -20 dBm and 0 dBm. The negative
sign is automatically applied to any non-zero value.
The settings for the audio levels are presented in the following order for
modification
B1290: Radio Code One is . . .(Radio Transmit Tone Level)
43 Program Codes
To Next Page
Loading...