Barnett Engineering ProTalk Plus B1290 - Different Alarms Dialing Different Numbers

YOU: 5** Select Configuration
B1290: Enter Configuration Code
YOU:
2** Select Using Directory
B1290: Alarm One is Directory is...
YOU:
1** Select Directory A
B1290: Alarm One is Directory is A
YOU:
** Next
Repeat this for all of the alarms
When you wish to dial from the B directory, call up the B1290 and follow
these steps:
B1290: Enter Control Code
YOU:
78 Directory Control Code
B1290: Telephone Format is Directory B
And to change it back:
B1290: Enter Control Code
YOU:
78 Directory Control Code
B1290: Telephone Format is Directory A
Example 3: Different Alarms Dialing Different Telephone Numbers
A B1290 is used in an application where there are two different types of re
-
lated alarms. Some are building alarms, such as intrusion alarms, building
temperature, power failure, etc. Others are alarms relating to specific
equipment failures, such as compressor failure, high tank level or sump
overflow. It is desirable to have the maintenance personnel alerted if there
is a building alarm, but if there is a problem with the equipment, it would
be preferable to alert the operations technicians.
In this example, alarms 1 and 2 are connected to intrusion alarm and build
-
ing high temperature respectively. These are building alarms, and are to
dial the building maintenance people at 255-9544 andthen 255-9598. Com
-
pressor failureand high tank level are fed toalarms 3 and4. Sincethese are
equipmentproblems,operationstechniciansat766-4422andthen 766-8901
are to bealerted. Follow the previousexample to enter the telephone num
-
bers in Directory A and Directory B then set the alarms to use these two di
-
rectories
B1290: Enter Program Code
YOU:
5** Select I/O Configuration
54 Programming Examples