YOU: 2** Change
B1290: ‘beep’
YOU:
#0 7664422 #8 **
[DIAL]7664422 [VOICE]
B1290: Directory B, Line One is DIAL VOICE
YOU:
** Next
B1290: Directory B, Line Two is...
YOU:
2** Change
B1290: ‘beep’
YOU:
#0 7668901 #8 **
[DIAL]7668901 [VOICE]
B1290: Directory B, Line Two is DIAL 7668901 VOICE
YOU:
** Next
B1290: Directory B, Line Three is...
YOU:
#** Quit
B1290: Enter Directory
YOU:
#** Quit
The telephone numbers have now been programmed. Now enter the Di-
rectory Control Code
B1290: Enter Program Code
YOU:
3** DTMF Codes
B1290: Enter DTMF Code
YOU:
7** Directory Control Code
B1290: Directory Control Code is...
YOU:
78** Enter Control Code
B1290: Directory Control Code is 78
YOU:
** Next
B1290: Enter Program Code
Right now the B1290 is programmed with dialing commands in Directory
A and Directory B. Any alarms that are to be switched between these two
directories should be programmed to use Directory A or the control code
will have no effect. Each alarm has its own setting for the directory it is us
-
ing. Makesurethatthealarmsyouwanttohavechangedaresetproperly.
53 Programming Examples
To Next Page
Loading...