Barnett Engineering ProTalk Plus B1290 - Call Progress; 7 Expanders; Number of Expanders

YOU: 0** Acknowledge request is not used
1** Acknowledge request is used
** Next
Default: 1 (enabled)
Call Progress (Dial Tone Enable)
This setting enables or disables the feature where the B1290 monitors the
audio activity on the phone line when it places a call. If enabled, Call Prog
-
ress will cause the B1290 to look for dial tone before dialing, watch for a
busysignal onthe called line and then wait until the calledparty speaksbe
-
fore the alarm announcement begins. Without Call Progress enabled, the
B1290 will perform the dial-out operation and speak regardless of the sig
-
nals encountered on the phone line.
Do not use the Answer command immediately following a Dial command
in the directories when Call Progress is enabled. This is the equivalent of
two Answer commands and may result in unreliable operation.
B1290: Dial Tone is …
YOU:
0** Call Progress is not used
1** Call Progress is used
** Next
Default: 1 (enabled)
Program Code 7 ÞÞ: Expanders
WhenProgramCode7isentered,theB1290givesyouthefollowingparam
-
eters.
Number of Expanders
Increase the capacity of a basic B1290 by adding up to 7 expanders, each
with an additional 8 alarm inputs and 4 relay outputs.
B1290: Expander Number is...
YOU:
X** Expanders(x=0to7)
** Next
Default: 0
42 Program Codes