When an alarm occurs, the B1290 will dial the number of the paging termi
-
nal, 255-9544; wait for the terminal to answer, wait 4 seconds while the ter
-
minal is prompting, then send the DTMF string 734 which represents the
calling site. Any alarm will result in the paging message 734.
If you want to distinguish between one alarm and another, use the Alarm
On Codes that can be assigned to each input.
B1290: Enter Program Code
YOU:
3** DTMF Codes
B1290: Enter DTMF Code
YOU:
4** Select Alarm On/Off Codes
B1290: Alarm One On Code is...
YOU:
*1* (pause) ** Code for alarm 1
B1290: Alarm One On Code is Þ1Þ
YOU:
** Next
B1290: Alarm One Off Code is...
YOU:
** Next
B1290: Alarm Two On Code is...
YOU:
*2* (pause) ** Code for alarm 2
B1290: Alarm Two On Code is Þ2Þ
YOU:
** Next
With this Alarm ON code programmed, the DTMF string Þ1Þ will be sent
immediately preceding the alarm one message when alarm one is active.
The message displayed on the pager will be: 734Þ1Þ
The string Þ2Þ will be sent with alarm two.
In this example, the same result could have been achieved by sending 734
as part of the alarm ON DTMF code. The 734 is included as part of the tele
-
phone number and is sent with every alarm. It appears much like a site
identifier.
This example also assumes that the pager could be dialed directly. Some
-
times a separate number for the pager must be dialed after the number for
the paging terminal. In that case, you might need to insert another delay,
and there might not be room to include the site identifier as part of the tele
-
phone number.
Another way the B1290 could be programmed to dial a paging terminal
wouldbetomakethealarmOnDTMFcodethesameasthetelephone num
-
59 Programming Examples
To Next Page
Loading...