Programs
A: R104GB09A.PMD
B: R104DE09A.PMD
E: 310304 / TCS
G: 140404 / T. Wenger
Section 9
Page 3
CNC selection
Once you have selected or created (in the same
way as a user variable) a CNC program (refer to
”SPS commands” in the handbook) the system
then switches to the corresponding CNC
program.
R10B4_120.BMP
Select the NC editor and enter the commands
using a keyboard. You can use all NC
commands specified in the B&R CNC
programming instructions (based upon
DIN66025 and ISO 6983).
Refer to the appendix:
NC154/NC156/NC157/NC158 (Cncpr_d1.pdf)
To Next Page
Loading...
