Palletising program
A: R104GB08A.PMD
B: R104DE08A.PMD
E: 310304 / TCS
G: 140404 / T. Wenger
Section 8
Page 3
PalProg PROGRAM NAME
RESET
The system waits for the RESET signal from
the palletising status page.
The PROGRAM NAME can be made up of a
maximum of 19 alphanumeric characters.
You can call up several palletising programs in
the user program.
A total of 5 palletising programs can be created
for each user program.
Important
When you are working with position
variables remember that these are saved
together with the program. Save the
program again after changing the position
variables.
Entering palletising program data
1 Select
Commands and palletising programs
must be selected/created before they
can be inserted/edited. To do this simply
press the ”Selection” button and enter a
new program name (in the same way as
for labels) or select an existing
palletising program.
To edit a program select ”Edit” and then
”Continue”
The system then switches to the menu
page of the palletising parameter input
area.
To Next Page
Loading...
