Battenfeld UNILOG B4 - Page 100

A: R104GB08A.PMD
B: R104DE08A.PMD
E: 310304 / TCS
G: 140404 / T. Wenger
Section 8
Page 4
Palletising program
2 Entering palletising parameters
1 Pal - Input
You can choose between two different sets of
parameters.
1.Pos;L.Pos;Qty
The first position, last position and
number of parts are specified here. The
spacing is calculated using these three
parameters and shown in the menu.
Specify the quantity for all three axes
(min. 1).
R10B4_114.BMP
1
2
3
4
6
5