Service pages
A: R104GB11A.PMD
B: R104DE11A.PMD
E: 010404 / TCS
G: 150404 / T. Wenger
Section 11
Page 9
The pneumatic axes may only be accessed by
Battenfeld Service engineers.
Here you can configure the type of pneumatic
axis and rename the axis group.
Types
1 Pneumatic axis with end position
sensors: 2 digital inputs and outputs.
2 Pneumatic axis with centre and end
position sensors: 3 digital inputs and
outputs.
3 Pneumatic axis with no end position
sensors: no digital inputs and 2 digital
outputs.
To Next Page
Loading...
