A: R104GB12A.PMD
B: R104DE12A.PMD
E: 010404 / TCS
G: 150404 / T. Wenger
Section 12
Page 6
Alarm list
General errors can be acknowledged by
selecting the 2nd softkey .
Select the 3rd softkey
to switch axes. If
there is no controller error the system switches
to the alarm list.
CNC errors are acknowledged by selecting the
5th softkey
.
These errors are also automatically
acknowledged by the acknowledge function in
the alarm list.
Description of
error messages
001 Emergency Stop 1 activated
Emergency Stop button on Manual
control device activated.
Release the button to
acknowledge the error.
002 Emergency Stop 2 activated
Second Emergency Stop activated (non
standard). Release the button to
acknowledge the error.
003 Emergency Stop 3 activated
3rd Emergency Stop activated (non
standard). Release the button to
acknowledge the error.
004 Emergency Stop 4 activated
Forth Emergency Stop activated (non
standard). Release the button to
acknowledge the error.
To Next Page
Loading...
